Filter
Top Products
Getting Started
10 312079A
2. Fill hopper with water or
compatible flushing solvent.
3. Plug sprayer in a grounded outlet.
4. Turn AllControl to
PRIME/CLEAN PUMP.
5. When sprayer starts
pumping, water or
flushing solvent and air
bubbles will be purged
from the system. Allow
fluid to drain out of prime
tube, into waste pail, until
all fluid has drained out of
hopper. Pour out any
remaining fluid.
6. Turn AllControl to OFF.
7. Fill hopper with paint.
8. Turn AllControl to
PRIME/CLEAN PUMP.
9. When paint comes out of
drain tube, turn AllControl to
OFF.
10. Clip drain tube to side of
hopper.
11. Point gun into waste pail.
12. Unlock gun trigger lock.
13. Pull and hold gun trigger.
14. Set AllControl to
PRIME/CLEAN GUN &
HOSE.
15. Continue to trigger into waste pail until you see
only paint coming out of gun.
16. Release trigger. Engage
trigger lock.
17. If spraying, install tip and guard on gun, page
13 and see Spraying Techniques, page 14.
If rolling, roller setup and Rolling Techniques,
begin on page 18.
ti9377a
ti9169a
ti9376a
ti9168a
ti9529a
ti9169a
ti9168a
ti9374a
ti8922a
ti9171a
ti8923a