Filter
Top Products
Shutdown & Cleaning - After Hopper Method Applications
312079A 21
13. To preserve paint in hose:
a. Add enough water or
cleaning solvent to refill
hopper. Point gun into
paint pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Turn AllControl to
PRIME/CLEAN GUN &
HOSE.
Continue to hold gun trigger until you see
paint diluted with flushing fluid starting to
come out of gun.
14. While continuing to
trigger gun, quickly move
gun to redirect spray into
waste pail. Continue
triggering gun into waste
pail until flushing fluid
dispensed from gun is
relatively clear and all the
flushing fluid has drained
from hopper.
15. Stop triggering gun. Engage
trigger lock.
16. Turn AllControl to OFF.
17. Follow Long Term Storage instructions, page
29.
18. Clip drain tube to hopper.
19. Use a soft brush to clean paint and debris off
strainer. Install strainer in hopper.
20. Clean gun fluid fil-
ter (d) with water or
flushing solvent
and a brush every
time you flush the
system. Replace
gun filter if dam-
aged.
21. Clean tip and guard with
water or flushing solvent.
A soft brush can be used
to loosen and remove
dried on material if
needed.
22. Use a soft cloth to wipe
off hopper, cover, and
hose. Install hopper
cover.
ti8922a
ti9171a
ti9745a
ti8923a
ti9168a
CAUTION
Do not immerse hopper. Water or cleaning
solvents will damage the internal sprayer
components.
d
ti9257a
ti9671a
ti9226a