Filter
Top Products
Shutdown & Cleaning - After Direct Immersion Method Applications
312079A 27
15. To preserve paint in hose:
a. Point gun into paint pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Turn AllControl to
PRIME/CLEAN GUN &
HOSE.
e. Continue to hold gun trigger until you see
paint diluted with water starting to come out
of gun.
16. While continuing to trigger
gun, quickly move gun to
redirect spray into waste
pail. Continue triggering
gun into waste pail until
water coming out of gun is
relatively clear.
17. Stop triggering gun. Engage
trigger lock.
18. Turn AllControl to OFF.
19. Turn off garden hose. Close
Power Flush attachment.
20. Unscrew Power Flush
attachment from suction tube.
21. Use a soft brush to clean paint
and debris off strainer and install
strainer in hopper.
22. Follow Long Term Storage instructions, page
29.
23. Clean gun fluid filter (d) with
water or flushing solvent
and a brush every time you
flush the system. Replace
gun filter if damaged.
24. Clean tip and guard with
water or flushing solvent.
A soft brush can be used
to loosen and remove
dried on material if
needed.
25. Wipe paint off outside of gun using a soft cloth
moistened with water or flushing solvent.
26. Use a soft cloth to wipe off hopper, cover and
hose.
Step 15 is for returning paint in hose back to
paint pail. One 25-ft (7.5-m) hose holds
approximately 1-pint (0.5-liter) of paint.
ti8922a
ti9171a
ti9745a
ti8923a
ti9168a
ti9413a
TIA
d
ti9257a
ti9671a