Graco 261800 Paint Sprayer User Manual


 
Shutdown & Cleaning - After Hopper Method Applications
22 312079A
Power Flush
Power flushing is a faster method of flushing. It can
only be used after spraying water-based coatings.
1. Relieve pressure, page 7.
2. If you used a spray gun, remove tip and guard
assembly from gun and place in flushing fluid.
If you used a roller, leave roller assembly
attached to gun.
3. Pour unused paint out
of hopper and back
into original container.
4. Place drain tube in
waste pail.
5. Use inlet screen handle
to remove inlet screen
from hopper. Place in
bucket of clean water or
cleaning solvent.
6. Turn AllControl to
PRIME/CLEAN PUMP to
remove excess paint in
hopper.
7. If you used a liner, carefully remove liner from
hopper and dispose of liner in a proper trash
container.
8. Screw power flush attachment to
garden hose.
9. Thread hose extender into
hopper inlet.
10. Connect Power Flush
attachment to hose extender.
11. Turn water on and open
valve.
12. Turn AllControl to
PRIME/CLEAN PUMP. Let
water flow out of drain tube,
into waste pail for 30
seconds.
13. Turn AllControl to OFF.
14.
a. If you used a spray gun
only, continue with Step
14.
b. If you used a roller follow Cleaning Roller
instructions beginning on page 28.
ti9292a
ti9376a
ti9378a
ti9168a
Step 15 is for returning paint in hose back to
paint pail. One 25-ft (7.5-m) hose holds
approximately 1-pint (0.5-liter) of paint.
ti9761a
ti9762a
ti9743a
ti9744a
ti9169a
ti9168a