Filter
Top Products
Shutdown & Cleaning - After Direct Immersion Method Applications
312079A 25
12. To preserve paint in hose:
a. Point gun into paint pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Turn AllControl to
PRIME/CLEAN GUN &
HOSE.
Continue to hold gun trigger until you see
paint diluted with flushing fluid starting to
come out of gun.
13. While continuing to
trigger gun, quickly move
gun to redirect spray into
waste pail. Continue
triggering gun into waste
pail until flushing fluid
dispensed from gun is
relatively clear.
14. Stop triggering gun. Engage
trigger lock.
15. Turn AllControl to OFF.
16. Follow Long Term Stor-
age instructions,
page 29.
17. Clip drain tube to hopper.
18. Use a soft brush to clean paint and debris off
strainer. Install strainer in hopper.
19. Clean gun fluid filter (d) with
water or flushing solvent
and a brush every time you
flush the system. Replace
gun filter if damaged.
20. Clean tip and guard with
water or flushing solvent.
A soft brush can be used
to loosen and remove
dried on material if
needed.
21. Wipe paint off outside of gun using a soft cloth
moistened with water or flushing solvent.
22. Use a soft cloth to wipe off hopper, cover, and
hose.
Step 12 is for returning paint in hose back to
paint pail. One 25-ft (7.5 m) hose holds
approximately 1-pint (0.5-liter) of paint.
ti8922a
ti9171a
ti9745a
ti8923a
ti9168a
d
ti9257a
ti9671a