Filter
Top Products
Getting Started
312079A 11
Direct Immersion Setup (Alternate Spray
Method)
1. Set AllControl to OFF.
2. Push down on bend of handle and pivot 90°.
Remove cover.
3. Use inlet screen handle to
unscrew and remove inlet
screen from hopper.
4. Unclip drain tube from side
of hopper.
5. Replace hopper cover and return handle to
locked position.
6. Stand sprayer upright in
immersion spray position.
7. Unscrew suction tube
fitting from hopper elbow
(b).
8. Install inlet screen into
end of suction tube.
9. Engage gun trigger lock.
10. Unscrew tip and guard
assembly from gun.
11. Uncoil hose and connect
one end to gun. Use two
wrenches to tighten
securely.
12. Connect other end of hose
to sprayer. Use two
wrenches to tighten
securely.
ti9168a
ti9290a
ti9291a
ti9302a
ti9828a
ti9294a
If hose is already connected, make sure con-
nections are tight.
b
ti9379a
ti9824a
ti8923a
ti9204a
ti9203a
ti9375a