Filter
Top Products
Getting Started
312079A 13
d. set AllControl to
PRIME/CLEAN GUN &
HOSE.
11. Continue to trigger into waste pail until you see
only paint coming out of gun.
12. Release trigger. Engage
trigger lock.
13. Transfer drain tube to paint pail and clip prime
tube to suction tube.
14. If spraying, install tip and guard on gun, page
13 and see Spraying Techniques, page 14.
If rolling, roller setup and Rolling Techniques,
begin on page 18.
Install Tip and Guard
1. Engage trigger lock.
2. Verify tip and guard parts are assembled in
order as shown below.
3. Screw tip and guard assem-
bly on gun. Tighten retaining
nut.
• Motor stopping indicates pump and hose
are primed with paint.
• If motor continues to run the sprayer is
not properly primed. To reprime repeat
step 6.
ti9171a
ti8923a
ti8923a
retaining nut
black rubber gasket and
guard
tip
ti8911a
metal seat
TIA
Use tip to align seat
in guard
.
Tip must be pushed
all the way into guard
ti9574a
ti9255a