Filter
Top Products
Shutdown & Cleaning - After Direct Immersion Method Applications
24 312079A
Shutdown & Cleaning - After Direct Immersion Method
Applications
Pail Flushing
1. Relieve pressure, page 7.
2. If you used a spray gun, remove tip and guard
assembly from gun and place in flushing fluid.
If you used a roller, leave roller assembly
attached to gun.
3. Lift suction tube and prime tube from paint pail.
Let them drain into paint for a while.
4. Separate prime tube
(smaller) from suction tube
(larger).
5. Place waste and
paint pail side by
side.
6. Submerge suction tube
in water or flushing
solvent.
7. Place prime tube in waste
pail.
8. Set AllControl to
PRIME/CLEAN PUMP.
9. Flush until approximately 1/3 of the flushing
fluid is emptied from the pail.
10. Turn AllControl to OFF.
11.
a. If you used a spray
gun only, continue
Pail Flushing, Step 12.
b. If you used a roller follow Cleaning Roller
instructions beginning on page 28.
• For short term shutdown periods (over-
night to one week) refer to Short Term
Storage, page 29.
• For flushing after spraying oil-based coat-
ings, use compatible oil-based flushing
fluid or mineral spirits.
• For flushing after spraying water-based
coatings, use water.
• If you are using water-based materials, you
have the option of following the cleanup
procedure described below, or for faster
cleanup, Power Flush, starting on page 26.
TIA
ti9726a
ti9827a
ti9825a
ti9169a
ti9168a