Filter
Top Products
Always operate the lathe with the headstock
firmly locked to the bed. Otherwise, serious
personal injury may occur.
To swivel the headstock:
1.
2.
Figure 17
3.
Figure
18
Figure 18.
4.
Note: The swivel pin can lock the headstock
at 45°, 90°, 135°, 180°, 270°, and 360°.
5.
Adjusting Tailstock
To position the tailstock along the length of
the bed:
1.
Figure 19
Figure 19.
2.
Note: The large clamping hex nut under-
neath the tailstock will require occasional
adjusting to ensure proper clamping pressure
of the tailstock to the bed. Turn this hex nut
in small increments to fine tune the clamping
pressure as needed.
Always operate the lathe with the tailstock
firmly locked to the bed. Otherwise, serious
personal injury may occur.