Grizzly G0632 Lathe User Manual


  Open as PDF
of 52
 



Aligning Centers
 


To align the centers:
1.      
       

2. 

   Figure 56   

Figure 56.

Changing Belt
To change the belt:
1.     

2.       
Figures 57 & 58
3. 

4.    
      

Figure 57.





Figure58

5.       
    
Changing Speed Ranges  Page 24 

6.        


7. Step 6.
8.       


Note: When properly tensioned, the belt
should deflect about
1
⁄4" when moderate pres-
sure is applied to the belt mid-way between
the upper and lower pulley.



 previous next