Spindle Turning
Figure 39
Figure 39.
Workpiece
Workpiece
Center
Pencil Lines
Marked Diagonally
Across Corners
Figure 40.
To set up a spindle turning operation:
1.
Figure 40
Make sure the headstock and tailstock cen-
ters are properly aligned before beginning
any turning operation. See Aligning Centers
on Page 38 for additional instructions on
this procedure. Failure to observe this warn-
ing could result in the workpiece being
thrown from the lathe resulting in serious
personal injury.
2.
3.
Damage to your eyes and lungs could result
from using this machine without proper pro-
tective gear. Always wear a face shield and
respirator when operating this machine.