Filter
Top Products
Outboard Turning
Figure 46
Figure 46.
Sanding / Finishing
Figure 47
Figure 47.
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Keep the lathe tool resting on a tool rest
the ENTIRE time that it is in contact with
workpiece or when preparing to make con-
tact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands into the workpiece.
Failure to heed this warning could result in
serious personal injury.
Wrapping the sandpa-
per completely around
the workpiece could pull
your hands into the mov-
ing workpiece and may
cause serious injury.
Never wrap sandpaper
or finishing materials
completely around the
workpiece.
Sandpaper
Workpiece