Grizzly G0632 Lathe User Manual


  Open as PDF
of 52
 


1/4"
Figure 41.
7.       

Installing Headstock CenterPage 21

Note: Use the tool rest to support the opposite
end of the workpiece so that the workpiece
and spur center do not separate.
8.        
     
     Page 22  

9.      
  


10.        
      


Do not press the workpiece too firmly with
the tailstock or the bearings will bind and
overheat. Likewise, do not adjust too loosely
or the workpiece will spin off the lathe. Use
good reason and care, otherwise, serious
personal injury could result.
4.        
 
     

Step 1
5. 
      

6.        



Figure 41
 previous next