Grizzly G0632 Lathe User Manual


  Open as PDF
of 52
 


Faceplate Turning

        

      

Figure 43.
To mount the workpiece onto the faceplate:
1.       Spindle
Turning Page 28
Note: Cut off corners of the workpiece to
make it as close to "round" as possible.
2.       
   
Figure 44
Figure 44.


3.       
    Headstock
Faceplate  Page 23 




To mount your workpiece to a backing block:
1. 

2.        

3. 


4. 
       
       

Note: Allow the glue to cure according to the
manufacturer's instructions.
Correct Wrong
Figure 45.

NOTICE
Only use tap screws or wood screws with
non-tapered heads (Figure 45) to attach the
faceplate to the workpiece. Do NOT use dry-
wall screws or screws with tapered heads
because they can split the faceplate, or the
screws may snap off during operation.
 previous next