Filter
Top Products
Headstock Faceplate
Faceplate Turning Page 31
To install the headstock faceplate:
1.
2.
Figure 26
4.
Figure 27
To prevent the faceplate and workpiece
separating from the spindle during opera-
tion, the headstock faceplate MUST be firmly
threaded onto the spindle and secured in
place by fully tightening the three faceplate
set screws. If these instructions are not
properly performed, serious personal injury
could occur.
Note: To remove the headstock faceplate, discon-
nect the lathe from the power source and perform
the steps above in reverse.
Figure 26.
3.
Figure 27.