Installing /Removing
Headstock Center
To install the headstock center:
1.
2.
Page 23
3.
4.
Figure 22
5.
To remove the headstock center with the
knockout tool:
1.
2.
3.
Figure 23
Make sure the headstock and tailstock cen-
ters are properly aligned before beginning
any turning operation. See Aligning Centers
on Page 38 for additional instructions on
this procedure. Failure to observe this warn-
ing could result in the workpiece being
thrown from the lathe resulting in serious
personal injury.
Figure 22.
Figure 23.