Grizzly G0632 Lathe User Manual


  Open as PDF
of 52
 


Installing /Removing
Tailstock Center


To install the center into the tailstock quill:
1.        

Figure 24
2. 


3. 
Figure 24
4. 


5. 
  Figure
25       

Figure 25.




6. 

To remove the center from the tailstock quill:
1. 
2. 
   

3. 



The tailstock quill must always be locked in
place during lathe operation. Before tighten-
ing the quill lock handle, it must be properly
aligned with the quill keyway. Otherwise,
the workpiece can be thrown from the lathe
causing serious personal injury or death.
Figure 24.



 previous next