Filter
Top Products
-30- G0504 16" Horizontal Resaw Bandsaw
To ensure optimum power transmission from the
motor to the blade and to the hydraulic pump,
the V-belts must be in good condition (free from
cracks, fraying and wear) and operate under
proper tension. Check the V-belts at least every 3
months; more often if the bandsaw is used daily.
See Section 8: Service Adjustments for instruc-
tions on properly tensioning the belts or for
replacing the belts, if needed.
Inside Wheel Cover
To keep the bandsaw working properly, regularly
open the wheel cover and vacuum sawdust.
Conveyor Belts
Use compressed air to clean the built-up sawdust
from the conveyor belts. Eye injuries frequently
occur when cleaning with compressed air—wear
safety glasses to protect yourself! Also wear a
dust mask or respirator to protect your lungs from
airborne dust particles.
Elevation Columns
Use a dry rag to remove sawdust from the eleva
-
tion columns and wipe the them down with a light
coat of oil.
Painted Surfaces
These areas may be cleaned with a dry or damp
rag; however, make sure you DO NOT clean
bare metal surfaces with a damp rag or they may
rust.
Motor
Vacuum dust off of the motor on a regular basis.
Built up dust acts as an insulator, making it dif
-
ficult for the motor to dissipate heat.
Hydraulic Components
Keep hydraulic components free of sawdust,
especially before working on them, to avoid con-
tamination of the hydraulic system.
Always be aware of the condition of your machine.
Routinely check the condition of the following
items and repair or replace as necessary:
• Loose mounting bolts
• Worn switch
• Worn or damaged blade
• Worn or damaged support bearings or guide
bearings
Always disconnect
power to the machine
before performing main
-
tenance. Failure to do
this may result in seri
-
ous personal injury.
Except for the bearings that are fitted with grease
fittings, the other bearings are sealed and pre-
lubricated and require no lubrication during their
usable life. All bearings are standard sizes, and
replacements can be purchased from our parts
department or a bearing supply store.
Bearings
V-Belts
Miscellaneous
Cleaning
SECTION 7: MAINTENANCE