Filter
Top Products
Model G0690/G0691 (Mfg. 11/10+)
-25-
11. G0690 ONLY: Install the 62" front rail rectan-
gular tube onto the 50" front rail with the three
M6-1 x 16 cap screws, 6mm flat washers,
and 6mm lock washers, as shown in Figure
20.
G0691 ONLY: Install the 82" front rail rect-
angular tube onto the 70" front rail with five
M6-1 x 16 cap screws, 6mm lock washers,
and 6mm flat washers, as shown in Figure
21.
Figure 21. Model G0691 tube attached to front
rail.
Figure 20. Model G0690 tube attached to front
rail.
10. Install the front rail onto the table and exten-
sion wings with four M8-1.25 x 40 hex bolts,
eight 8mm flat washers, four 8mm lock wash-
ers, and four M8-1.25 hex nuts, as shown in
Figure 19.
Before final tightening, make sure the front
rail is set
3
⁄16" below the beveled edge of the
main table and extension wings along its
entire length.
Figure 19. Front rail installed (Model G0690
shown).
12. Attach the rear rail to the holes on the main
table using two
5
⁄16"-18 x 1" hex bolts, 8mm
lock washers and 8mm flat washers, as
shown in Figure 22.
x5
x3
Figure 22. Rear rail installed (Model G0691
shown).
x2
13. Secure the rear rail to the extension wings
with two M8-1.25 x 40 hex bolts, four 8mm
flat washers, two 8mm lock washers and two
M8-1.25 hex nuts.