Filter
Top Products
-26-
Model G0690/G0691 (Mfg. 11/10+)
Note: Before tightening the fasteners, check to
make sure the top edge of the rear rail is flush
with the lowest edge of both T-slots (see Figure
23), so the miter gauge will slide smoothly when
installed later.
Figure 23. Verifying rear rail is flush with bottom
of T-slot.
G0690 Extension Table
1. Install the extension table between the front
and rear rails with the four M8-1.25 x 30 hex
bolts, eight 8mm flat washers, four 8mm
lock washers, and four M8-1.25 hex nuts, as
shown in Figure 24.
2. Using a long straightedge, adjust the exten-
sion table so it is flat (both flush and paral-
lel) with the main table and extension wings
(Figure 25), then tighten the fasteners.
Figure 24. Model G0690 extension table
installed.
Figure 25. Adjusting Model G0690 extension
table flush with extension wing and table.
G0691 Extension Table
1. Remove the six M8-1.25 x 30 hex bolts, (12)
8mm flat washers, six 8mm lock washers,
and six M8-1.25 hex nuts from the extension
table.
2. While an assistant holds the extension table
between the front and rear rails, fasten the
extension table to the rails with the fasteners
removed in Step 1.
3. Thread the feet into the legs with the two
M8-1.25 x 60 hex bolts, place the legs under
the table, and thread the feet out until the top
of each leg is against the underside corner of
the table.
4. Use the four M8-1.25 x 20 cap screws, 8mm
lock washers, flat washers, and M8-1.25
hex nuts to secure the legs to the end of the
extension table, as shown in Figure 26.
Figure 26. Model G0691 extension table
installed.
x4
Foot