Filter
Top Products
-64-
Model G0690/G0691 (Mfg. 11/10+)
Symptom Possible Cause Possible Solution
Blade is not aligned
with miter slot or
fence.
1. Blade is warped.
2. Table top is not parallel to blade.
3. Fence is not parallel to blade.
1. Replace blade (Page 36).
2. Make table parallel to blade (Page 67).
3. Make fence parallel to blade (Page 69).
Blade does not
reach 90°.
1. 90° stop bolt is out of adjustment.
2. Sawdust stuck on stop bolt.
1. Adjust 90° stop bolt (Page 65).
2. Clean sawdust off stop bolt.
Blade hits insert at
45°.
1. 45° stop bolt is out of adjustment.
2. Sawdust stuck on stop bolt.
3. Hole in insert is inadequate.
4. Table out of alignment.
5. Blade position is incorrect.
1. Adjust 45° stop bolt (Page 65).
2. Clean sawdust off stop bolt.
3. File or mill the hole in the insert.
4. Align blade to the table (Page 67).
5. Adjust blade position.
Board binds or
burns when feeding
through table saw.
1. Dull blade.
2. Blade is warped.
3. Fence is not parallel to blade.
4. Table top is not parallel to blade.
1. Replace blade.
2. Replace blade (Page 36).
3. Make fence parallel to blade (Page 69).
4. Make table parallel to blade (Page 67).