Filter
Top Products
-16-
Model T25920/T25926 (Mfd. Since 08/14)
Assembly
Assembly consists of installing the electrical box
onto the base with two pre-installed Phillips head
screws, then installing the handwheel handle onto
the tailstock quill with the pre-installed flathead
screw.
To assemble machine:
1. Use (2) pre-installed Phillips head screws
and (2) flat washers to attach electrical box
to lathe, as shown in Figure 12.
2. Insert handwheel handle into quill handwheel
and tighten with flathead screwdriver.
3. To insert centers, refer to Installing/
Removing Headstock Center and Installing/
Removing Tailstock Center on Page 22.
Tes t Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
4. Remove key from toggle switch, as shown
below.
Figure 13. Removing key from toggle switch.
5. Try to start machine.
— Machine should NOT start. If it does start,
switch disabling feature is not functioning
properly and switch must be replaced.
Figure 12. Electrical box installed.
Electrical Box
x2