Filter
Top Products
Model T25920/T25926 (Mfd. Since 08/14)
-23-
Removing Live Center from Tailstock
1. Loosen quill lock handle (if locked) approxi-
mately half a turn.
2. Turn quill handwheel counterclockwise until
tailstock quill fully retracts, causing live center
to be forced out of quill.
4. Tighten quill lock handle.
Quill
Live Center
Figure 26. Typical live center installation.
Quill Lock Lever
Quill
Handwheel
3. Insert live center, as shown in Figure 26,
and push firmly.
Removing/Installing
Faceplate
These instructions cover removing and installing
the faceplate. To mount a workpiece to your face-
plate, refer to Faceplate Turning on Page 27.
Removing Faceplate
1. DISCONNECT MACHINE FROM POWER!
2. Hold headstock handwheel securely while
turning faceplate counterclockwise until it is
removed. If the spur center is installed, it will
be removed during this process.
Installing Faceplate
1. DISCONNECT MACHINE FROM POWER!
2. Thread faceplate onto spindle shaft until
secure against shoulder on spindle shaft.
Figure 27. Typical faceplate removal.
Faceplate
Headstock
Handwheel
Tailstock quill must always be locked during
lathe operation. Workpiece can be thrown
from lathe if this step is not observed. Also,
tailstock quill should not protrude from
tailstock housing more than 2'' or quill will
not be supported enough. Failure to follow
warnings may result in personal injury.