Filter
Top Products
-22-
Model T25920/T25926 (Mfd. Since 08/14)
Figure 25. Typical spur center removal from
headstock spindle.
Knockout Rod
Installing /Removing
Tailstock Center
The included live center installs into the tailstock
with an MT#2 tapered fit.
Installing Live Center in Tailstock
1. Loosen quill lock handle (if locked) approxi-
mately half a turn.
2. Rotate quill handwheel clockwise until quill
protrudes about
3
⁄4".
Removing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Insert knockout rod into outboard end of
spindle. Use a shop rag or wear a glove to
catch center and gently tap rod handle until
spur center is freed from spindle (see Figure
25).
Installing /Removing
Headstock Center
The spur center installs in the headstock spindle
with an MT#2 taper fit.
Tools Needed:
Gloves ............................................................... 1
Knockout Rod .................................................... 1
Figure 24. Typical installation of spur center into
headstock.
Spur Center
Spur center is sharp and may cause cuts.
Wear gloves when installing spur center.
4. Check that center is securely installed by giv-
ing it a quick tug. (A properly installed center
will not pull out by hand.)
Installing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Make sure surface of center and spindle are
free of debris and oily substances before
inserting center.
3. Insert tapered end of center into spindle, and
push it in quickly and firmly (see Figure 24).
Spur Center