Filter
Top Products
Model T25920/T25926 (Mfd. Since 08/14)
-35-
Figure 52. Belt removal (pulley removed for
clarity).
7. Place new belt over spindle pulley.
8. Slide spindle back through headstock and into
original position. A mallet may be required to
reseat bearing.
9. Install headstock spindle handwheel and
tighten both set screws.
10. Loosely install belt on inner or outermost
motor pulley position.
11. Move belt tension lever down to tension belt
then tighten belt tension screw.
12. Follow Step 4 in the Tensioning Belt proce-
dure to set belt tension.
13. Re-install rear access cover and close side
access cover.
Replacing Fuse
This lathe features an on-board fuse designed
to protect sensitive electrical parts from ther-
mal damage in the event of an overload. If the
machine does not start check the fuse.
To replace fuse:
1. DISCONNECT MACHINE FROM POWER!
2. Remove (4) Phillips head screws holding
electrical box to side access cover (see
Figure 53).
Figure 54. 10A fuse location on circuit board.
3. Carefully remove fuse, then insert new fuse
shown in Figure 54.
Figure 53. Electrical box screw locations, (side
access door open for clarity).
4. Re-install electrical box onto side access
cover with screws removed in Step 2, then
test run.
Phillips Head
Screws