Filter
Top Products
-14-
Model T27313 (Mfd. Since 01/15)
SECTION 3: OPERATIONS
Operation Overview
To complete a typical operation, the operator
does the following:
1. Examines workpiece to make sure it is suit-
able for cutting.
2. Adjusts cutting tool and stylus to make sure
they are aligned.
3. Puts on safety glasses, face shield, and a
respirator.
4. Turns lathe ON.
5. Gradually advances cutting tool over multiple
passes; until stylus makes contact with tem-
plate.
6. Turns lathe OFF immediately after turning
is complete and waits for workpiece to com-
pletely stop before removing it.
7. Repeats Steps 1–6 to complete all copies.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and
seek additional training from expe-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
Eye injuries or respiratory problems can
occur while operating this tool. Wear per-
sonal protective equipment to reduce your
risk from these hazards.