Filter
Top Products
Model T27313 (Mfd. Since 01/15)
-7-
SECTION 2: SETUP
Your machine was carefully packaged for safe
transportation. Remove the packaging materials
from around your machine and inspect it. If you
discover any damage, please call us immediately
at (570) 546-9663
for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi-
tion of your shipment, inventory the contents.
Unpacking
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials shipped with this
machine. Discard immediately.
The following are needed to complete the setup
process, but are not included with your machine.
Description Qty
• Additional People ....................................... 1
• Safety Glasses ........................................... 1
• Cleaner/Degreaser (Page 8) ...... As Needed
• Disposable Shop Rags ............... As Needed
• Screwdriver Phillips #2 ............................... 1
• Wrench or Socket 16mm ............................ 1
• Hex Wrench 4mm ....................................... 1
• Feeler Gauge ............................................. 1
• Machinist's Square ..................................... 1
Needed for Setup
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 2) Qty
A. Copy Attachment ........................................ 1
B. Longitudinal-Feed Handwheel .................... 1
C. Support Arm Clamping Plates .................... 2
D. Support Arms (Short) ................................. 2
E. Support Arms (Tall) .................................... 2
F. Hardware Bag (Not Shown) ........................ 1
—T-Bolts M10-1.5 x 100 ............................. 2
—T-Bolts M10-1.5 x 45 ............................... 2
—Cutting Tool ............................................ 1
—Support Arm Clamps .............................. 2
—Fender Washers 8mm ........................... 2
—Hex Nuts M8-1.25 .................................. 2
Figure 2. T27313 inventory.
A
B
C
DE
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.