Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 11
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts Lists on pages 31
and 32 are included. If any parts are missing or broken, please call Harbor Freight Tools
at the number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE:
For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram on page 33.
1. CAUTION! Always make sure the Power Switch (164) for the Bandsaw is in
its “OFF” position and the tool is unplugged from its electrical outlet prior to
assembling the tool, adding any accessories, or making adjustments to the tool.
To Assemble The Stand:
1. Insert the Pull Handle (173) into the two mounting holes located in the upper
section of one Stand (174). Then secure the Pull Handle to the Stand, using two
Pins (172). (See Figure E.)
2. Attach one end of the Tool Plate (175) to the upper section of one Stand (174),
using two Screws (178), two Flat Washers (177), and two Nuts (176).
(See Figure E.)
3. Attach the other end of the Tool Plate (175) to the upper section of the remaining
Stand (174), using two Screws (178), two Flat Washers (177), and two Nuts
(176). (See Figure E.)
PULL HANDLE
(173)
TOOL PLATE
(175)
STAND
(174)
STAND
(174)
FLAT WASHER
(177)
SCREW
(178)
NUT
(176)
PIN
(172)
FLAT WASHER
(180)
NUT
(181)
HEX BOLT (183)
FLAT WASHER (184)
SPRING WASHER (185)
PIN
(188)
WHEEL SHAFT
(187)
WHEEL (182)
WHEEL BRACKET (186)
FIGURE E