Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 25
7. Turn the Power Switch (164) to its “ON” position, and slowly lower the Body
Frame (60) until the Saw Blade (82) is just above the workpiece cut line.
(See Figure X.)
8. Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade
(82) tension or machine vibration. If this is found, turn off the Bandsaw and
correct the problem before using. (See Figure X.)
9. Allow the Saw Blade (82) to turn up to full speed before feeding the Saw Blade
into the workpiece. (See Figure X.)
10. WARNING! Always keep hands and fingers safety away from the
cutting area.
11. Slowly lower the Body Frame (60), while it gradually feeds the Saw Blade (82)
into the workpiece. Do not force the Bandsaw to remove material faster than it is
designed to cut. (See Figure X.)
12. Never attempt to remove material stuck in the moving parts of the Bandsaw while
it is plugged in and running. Turn off the Bandsaw if the workpiece is to be
backed out of an uncompleted cut.
13. IMPORTANT: When in the horizontal cutting mode only, the Switch Push-Off Tip
(41) will automatically turn the Power Switch (164) to its “OFF” position and shut
off the Bandsaw’s Motor when the cut has been completed. (See Figure X.)
14. Once the cut is made, check to make sure the Power Switch (164) is in its “OFF”
position. Then, unplug the Power Cord Plug from its electrical outlet.
(See Figure X.)
15. Wait until the Saw Blade (82) comes to a complete stop. Next, raise the Body Frame
(60) to its full vertical position, making sure it locks in place by turning the Support
Plate (150) to the right until it firmly locks into the Body Frame. Remove the work-
piece from the Vise assembly (138, 141) and scrap material from the Machine Bed
(142) of the Bandsaw. Then, slowly lower the Body Frame (60) to its horizontal
position and lock it in place with the Locking Pin (115). (See Figure X.)
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Power Switch (164) is in its “OFF” position and
the tool is unplugged from its electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
2. Before each use, inspect the general condition of the Bandsaw. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts,