Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 17
OPERATING INSTRUCTIONS
1. CAUTION! Always make sure the Power Switch (164) for the Bandsaw is in
its “OFF” position and the tool is unplugged from its electrical outlet prior to
making adjustments to the tool.
To Use The Vise:
1. Raise the Body Frame (60) to its vertical position, and lock the Body Frame in
place with the Support Plate (150) and Locking Pin (153). (See Figure M.)
2. Open the Moveable Vise Plate (141) to accept the piece of material to be cut by
rotating the Hand Wheel (171) counterclockwise. (See Figure P.)
3. Place the workpiece on the Machine Bed (142). If the workpiece is long, support
the end. (See Figure P.)
4. Clamp the workpiece firmly with the Moveable Vise Plate (141) by rotating the
Hand Wheel (171) clockwise. (See Figure P.)
MOVEABLE VISE PLATE (141)
HAND WHEEL
(171)
FIGURE P
Support (191) to the Vertical Cutting Plate (189), using one Flat Washer (192)
and one Nut (193). Remove the Hex Head Bolt (61). Position the Vertical Cut-
ting Plate Support against the Body Frame (60). Then firmly re-tighten the Hex
Head Bolt. (See Figures N and O.)
HEX HEAD BOLT (61)
VERTICAL
CUTTING PLATE
(189)
SCREW (190)
FLAT WASHER (192)
NUT (193)
VERTICAL CUTTING PLATE SUPPORT (191)
FIGURE O
MACHINE BED (142)