Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 22
Adjusting The Blade Guide Brackets:
1. The Right Blade Guide Bracket (90) and Left Blade Guide Bracket (102) are
adjustable by loosening the Guide Adjusting Knob (45) and sliding the
Brackets up or down to accomodate the depth of the workpiece. (See Figure V.)
2. The Blade Guide Brackets (90, 102) should be set as close as possible to the
workpiece, without interfering with the workpiece or contacting the Machine Bed
(142). (See Figure V.)
3. Once the adjustment is made, make sure to re-tighten the Guide Adjusting Knob
(45). (See Figure V.)
Basic Bandsaw Operation -- Vertical Position:
1. WARNING! Always wear ANSI-approved safety impact eye goggles when
operating the Bandsaw.
2. Do not plug the Power Cord Plug into an electrical outlet until all neces-
sary adjustments (as previously discussed in this manual) have been made.
3. Raise the Body Frame (60) to its full vertical position, making sure it locks in
place by turning the Support Plate (150) to the right until it firmly locks into the
Body Frame and inserting the Locking Pin (153). (See Figure W,
next page.)
4. Once all necessary adjustments to the Bandsaw have been made, plug the
Power Cord Plug into the nearest 120 volt, grounded, electrical outlet.
BLADE GUIDE BRACKETS
(90, 102)
GUIDE ADJUSTING KNOB
(45)
FIGURE V