Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 24
14. Once the cut is made, turn the Power Switch (164) to its “OFF” position.
Then, unplug the Power Cord Plug from its electrical outlet. (See Figure W.)
15. Wait until the Saw Blade (82) comes to a complete stop. Then, remove the work-
piece and scrap material from the Vertical Cutting Plate (189).
(See Figure W.)
16. Remove the Locking Pin (153) and turn the Support Plate (150) to the left. Then,
lower the Body Frame (60) to its horizontal position. (See Figure W.)
Basic Bandsaw Operation -- Horizontal Position:
1. WARNING! Always wear ANSI-approved safety impact eye goggles when
operating the Bandsaw.
2. Do not plug the Power Cord Plug into an electrical outlet until all neces-
sary adjustments (as previously discussed in this manual) have been made.
3. Raise the Body Frame (60) to its full vertical position, making sure it locks in
place by turning the Support Plate (150) to the right until it firmly locks into the
Body Frame and inserting the Locking Pin (153). (See Figure W.)
4. Secure the workpiece in the Vise assembly (138, 141). When cutting a large
workpiece, make sure its entire length is properly supported. If necessary, use a
roller stand (not included) with a larger workpiece. (See Figure X.)
5. If cutting several workpieces at the same length, you may wish to adjust the
Stock Stop (157) to the desired position. (See Figure X.)
6. Once all necessary adjustments to the Bandsaw have been made, plug the
Power Cord Plug into the nearest 120 volt, grounded, electrical outlet.
(See Figure X.)
VISE ASSY.
(138, 141)
STOCK STOP
(157)
BODY FRAME
(60)
SUPPORT PLATE
(150)
POWER SWITCH
(164)
FIGURE X
SWITCH PUSH-OFF TIP
(41)
LOCKING PIN
(153)