Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 16
To Convert The Bandsaw For Vertical Use:
1. NOTE: Notching, slitting, and contour work is best done with the Bandsaw in its
vertical position.
2. Raise the Saw Head to its full vertical position, making sure it locks in position by
turning the Support Plate (150) to the right until it firmly locks into the Body
Frame (60) and inserting the Locking Pin (153). (See Figure M.)
3. Remove the two Screws (190), and remove the Small Vertical Cutting Plate
(194). (See Figure N.)
4. Guide the Saw Blade (82) through the slot in the Vertical Cutting Plate (189),
and secure it in position with the two Screws (190). (See Figure N.)
5. Insert one Screw (190) downward through the mounting hole in the Vertical
Cutting Plate (189). Attach the top section of the Vertical Cutting Plate
FIGURE M
SCREW (190)
SMALL VERTICAL CUTTING PLATE (194)
SCREW (190)VERTICAL CUTTING PLATE (189)
FIGURE N
SUPPORT PLATE (150)
BODY FRAME (60)
LOCKING PIN (153)