Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 12
To Attach The Wheels To The Stand:
1. Align the two mounting holes in the Wheel Bracket (186) with the two mounting
holes located in the lower section of the Stand (174). Then secure the Wheel
Bracket to the Stand, using two Hex Bolts (183), two Spring Washers (185), two
Flat Washers (184), two Flat Washers (180), and two Nuts (181).
(See Figure E, previous page.)
To Attach The Bandsaw To The Stand:
1. With additional manpower, and an adequate lifting device, carefully set the
Bandsaw on top of the Stand assembly, making sure the upper section of the
Stand fits
outside
the base of the Bandsaw. (See Figure F.)
2. Align the
three
threaded mounting holes in each end at the base of the Bandsaw
with the three mounting holes located at each end of the Stand assembly. Then
secure the Bandsaw to the Stand assembly, using three Screws (59), three
Spring Washers (58), and three Flat Washers (57). (See Figure F.)
STAND
(TOP VIEW)
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
SCREW (59)
SPRING WASHER (58)
FLAT WASHER (57)
FIGURE F
To Attach The Stock Stop Assembly:
1. When mounted to the Bandsaw, the adustable Stock Stop assembly is used to
make repetitive cuts of the same length.
2. To attach the Stock Stop assembly, slide the Shaft (158) into the mounting hole
in the Machine Bed (142), and secure the Shaft by tightening the Hex Bolt (149).
(See Figure G, next page.)
3. Slide the Stock Stop (157) onto the Shaft (158), and secure by tightening the
Socket Head Screw (156). (See Figure G.)