Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 23
5. Turn the Power Switch (164) to its “ON” position. (See Figure W.)
6.
CAUTION! Cut only
flat
workpieces when the Bandsaw is in its vertical
position. Never attempt to cut pipes or other round objects with the Bandsaw in
its vertical position.
7. Before cutting, turn on the Bandsaw and check for excessively loose Saw Blade
(82) tension or machine vibration. If this is found, turn off the Bandsaw and
correct the problem before using. (See Figure W.)
8. Set the workpiece on the Vertical Cutting Plate (189), making sure to keep down-
ward pressure on the workpiece throughout the cutting process.
(See Figure W.)
9. When cutting a large workpiece, make sure its entire length is properly sup-
ported. If necessary, use a roller stand (not included) with a larger workpiece.
10. Allow the Saw Blade (82) to turn up to full speed before feeding the workpiece
into the Saw Blade. (See Figure W.)
11.
WARNING! Always keep hands and fingers safety away from the cutting
area.
12. Feed the workpiece into the Saw Blade (82) gradually. Do not force the Bandsaw
to remove material faster than it is designed to cut. (See Figure W.)
13. Never attempt to remove material stuck in the moving parts of the Bandsaw while
it is plugged in and running. Turn off the Bandsaw if the workpiece is to be
backed out of an uncompleted cut.
SAW BLADE
(82)
VERTICAL CUTTING PLATE
(189)
POWER SWITCH
(164)
BODY FRAME
(60)
SUPPORT PLATE
(150)
FIGURE W
LOCKING PIN (153)