Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 27
V-BELT (10)
SPINDLE PULLEY
(1)
MOTOR PULLEY
(79)
HEX BOLT
(70)
FIGURE Z
E. Place the new Saw Blade (82) between each of the Guide assemblies and
around the Upper Blade Wheel (37) and Lower Blade Wheel (54).
IMPORTANT: The teeth must be pointing
downward toward the Motor.
(See Figure Y.)
F. NOTE: The Bandsaw is equipped with a 64” diameter, .025” thick, 15/32” wide,
14 teeth per inch Saw Blade (82). The machine will also accept Blades in 4,
6, 8, and 10 tooth sizes. The choice of Blade pitch is determined by the thick-
ness of the material to be cut. The thinner the workpiece, the more teeth is
recommended. A minimum of 3 teeth should engage the workpiece at all
times for proper cutting. (See Figure Y.)
CAUTION: If the teeth of the Saw Blade are so far apart that they straddle
the workpiece, severe damage to the workpiece and/or Saw Blade will
result.
G. Tighten the tension on the new Saw Blade (82) by turning the Blade Tension
Knob (34). (See Figure Y.)
H. Close the Blade Back Cover (114). (See Figure Y.)
4. To replace the V-Belt: The Bandsaw uses a size 0-506 V-Belt (10). To replace
the V-Belt:
A. Open the Pulley Cover (72). (See Figure Z.)
B. Loosen the Hex Bolt (70) to release tension on the old V-Belt.
(See Figure J.)
C. Remove the old V-Belt (10) from the two Pulleys (1, 79).
(See Figure Z.)
D. Place the new V-Belt (10) into the proper Pulley (1, 79) combination for the
desired Blade speed. (See Figures L and Z.)