Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 26
damaged electrical wiring, and any other condition that may affect its safe opera-
tion. If abnormal noise or vibration occurs, have the problem corrected before
further use.
Do not use damaged equipment.
3. Before each use, inspect the Saw Blade (82). Using a dull Saw Blade will cause
excessive wear on the Motor of the Bandsaw and will not produce a satisfactory
cut. Replace with a new Saw Blade when needed. To replace a Saw Blade:
A. NOTE: Make sure to wear heavy duty work gloves to avoid accidental cuts
from the Saw Blade (82) when performing this procedure.
B. Raise the body Frame (60) to its full vertical position, making sure it locks in
place by turning the Support Plate (150) to the right until it firmly locks into the
Body Frame, and insert the Locking Pin (153). (See Figure W.)
C. Release Saw Blade (82) tension by turning the Blade Tension Knob (34). (See
Figure Y.)
D. Slip the old Saw Blade (82) off the Upper Blade Wheel (37), Lower Blade
Wheel (54), and Guide assemblies. (See Figure Y.)
FIGURE Y
UPPER BLADE WHEEL
(37)
LOWER BLADE WHEEL
(54)
SAW
BLADE
(82)
BLADE BACK COVER
(114)
BLADE TENSION KNOB
(34)
UPPER
GUIDE
ASSY.
LOWER
GUIDE
ASSY.
TEETH POINTING
DOWNWARD