Filter
Top Products
CHAPTER 2
Setup and Configuration
StudioPix™ Pixelation Luminaire User Manual 9
Truss Mounting
If you are mounting the fixture(s) on a truss or another type of support, verify that the truss or
support will handle the weight of all the devices you are mounting.
Safety Cable
High End Systems strongly recommends that you use a safety cable when mounting any fixture.
You must supply your own safety cable and verify that the cable is capable of supporting the
weight of the fixture. You can order galvanized safety cables from your High End Systems
dealer/distributor (see
Related Products and Accessories on page 3).
Clamp
You must supply your own clamps and verify the clamp is capable of supporting the weight of
the fixture. You can order deluxe C-clamps for a two-inch truss from your High End Systems
dealer/distributor (see
Related Products and Accessories on page 3).
Mounting Procedure
To mount StudioPix fixtures on a truss:
1. Disconnect power to the fixture. If the fixture has been operating, allow the fixture to cool
before handling.
2. Always stand on a firm, stable surface when mounting a fixture to its support. The fixture
should be at a height where you can comfortably work on it, and should either be resting on
a stable surface, or held securely.
3. Attach suitable clamps through the center holes on the base of the fixture. Install two
locking washers per clamp when attaching the clamps to the fixture’s base.
4. Tighten the clamps firmly to the fixture’s base and to the support.
5. Loop one or more suitable safety cables around the support, through the side holes in the
fixture’s base, and around the fixture’s handles.
Holes for
attaching
clamps
Holes for
securing
safety cables
safety
cable
truss
clamp
locking
washers