Hitachi C 12RSH Saw User Manual


 
18
Fig. 46
Fig. 47
Fig. 48
Fig. 49
Cutting method of crown molding without tilting the saw blade
(1) Crown molding Stopper (L) and (R) (optional
accessories) allow easier cuts of crown molding
without tilting the saw blade. Install them in the
base both-sides side to be shown in Fig. 50-a. After
inserting Tighten the 6mm knob bolts to secure
the crown molding Stoppers.
[Optional accessories used]
•Crown molding Vise Ass’y (Include Crown molding
Stopper (L))
Crown molding Stopper (L)
Crown molding Stopper (R)
Fig. 50-a
(2) The crown molding vise (B) (Optional accessory)
can be mounted on either the left fence (Fence (B))
or the right fence (Fence (A)). It can unite with the
slope of the crown molding and vice can be
pressed down.
Then turn the upper knob, as necessary, to securely
attach the crown molding in position. To raise or lower
the vise assembly, first loosen the 6mm knob bolt.
After adjusting the height, firmly tighten the 6mm
wing bolt; then turn the upper knob, as necessary,
to securely attach the crown molding in position.
(See Fig. 50-b)
Fence
6mm knob bolt
Crown molding vise ass’y
(Optional accessories)
Knob
Crown molding
6mm
wing bolt
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
Fig. 50-b
WARNING
Always firmly clamp or vise to secure the crown
molding to the fence; otherwise the crown molding
might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade
may contact the sub fence, resulting in an injury.
CAUTION
Always confirm that the motor head (see Fig. 1) does
not contact the crown molding vise ass’y when it is
lowered for cutting. If there is any danger that it may
do so, loosen the 6mm knob bolt and move the crown
molding vise ass’y to a position where it will not
contact the saw blade.
Fence (A)
Base
Miter angle scale
Bevel angle scale
Head
Turntable
4
1
Bevel angle scale
Fence (B)
Miter angle scale
Base
Turntable
Head
2
3
Fence
Table on base
B
A
Fence
A
B
6mm knob bolt
6mm wing bolt
Crown molding
stopper (R)
(optional accessories)
Crown molding vise ass’y
(optional accessories)
6mm knob
bolt
Crown molding stopper (L)
(Optional accessories)
Table on base
03Eng_C12LSH_Eng 4/26/07, 5:32 PM18