Filter
Top Products
SET-UP
16 - HUSQVARNA
Set the brake rod assembly into the brake bracket. 7.
The brake rod assembly needs to be adjusted
before connecting the yoke to the brake. Turning
the yoke clockwise shortens the rod, tightening
the grip on the brake disc by the brake pads.
Counterclockwise loosens the clamping force.
After adjustment, attach the yoke to the brake’s 8.
top mounting hole using the clevis pin and cotter
pin.
Turn the adjustment nut against the spring and 9.
washer until the spring set snugly against the
brake bracket and has a small amount of tension.
With proper brake adjustment, the wheel will slide,
but not turn, when the handle is over center.
To engage brake, pull back on the handle until
brake rod assembly goes “over center” and locks
the brake ON. Test for proper tension and grip.
Remove air cleaner and double wire clamp from 10.
engine.
CLAMP
THREAD WIRE HARNESS
AND THROTTLE CABLE
GUIDE
CLEVIS PIN
HAIR PIN
Route the wire harness from engine and the throttle 11.
cable through guide and handle crossmember.
Connect upper and lower wire harness together, 12.
yellow to yellow—black to black.
ADJUSTMENT NUT
BRAKE BRACKET