Filter
Top Products
MAINTENANCE
HUSQVARNA-39
Drive Belt
Remove the belt guard by removing the three 1.
acorn nuts and lockwashers on the front of the belt
guard.
WARNING!
Prevent the engine from being
started by removing the ignition
cable from the spark plug.
8060-226
8060-227
Check that the belt is properly tensioned by 2.
squeezing the belt together. It should be possible
to squeeze the belt down about ¼ -
3
/8" (6 - 10
mm) from the original position.
Loosen screws holding cover plate to belt guard 3.
backing plate.
Undo the two screws (A) on each side of the 4.
cutting shroud.
COVER PLATE
SCREWS
8062-006