Filter
Top Products
LUBRICATION
HUSQVARNA-45
Right wheel
Lubricate using a grease gun until the grease
squeezes out one nipple.
Use good quality MP grease. Grease from well-known
brand names (petrochemical companies, etc.) usually
maintains a good quality.
Throttle cable
Peel back the rubber covers at both of the cable
mountings. Grease both ends of the throttle cable
and move the controls to end stop positions when
lubricating. Ret the rubber covers on the cable after
lubrication. Cables with sheaths will bind if they are
not lubricated regularly. Binding in a cable may cause
malfunction.
If the cable binds, remove the cable and hang it
vertically. Lubricate it with thin engine oil until the oil
begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that
it seals against the casing and allow the cable to hang
vertically from the bag overnight. If you do not succeed
in lubricating the cable, it must be replaced.
8011-231
8011-234
Checking Engine Oil Level
Make sure that the machine is parked on at ground
with the engine stopped when checking the oil level.
Unscrew the dipstick and wipe it using paper towel 1.
or a lint-free rag.
Replace the dipstick without screwing it in. 2.
Remove and check the level on the dipstick.
Fill oil as necessary to the lip of the dipstick hole. 3.
Oil type, see above.
Check that the rubber gasket is in position and 4.
screw the dipstick back into place. DO NOT
tighten it askew or too hard or you may damage
the threads.
8011-020