Filter
Top Products
CONTROLS
24 - HUSQVARNA
Throttle
The lever controls engine speed.
With the lever down, the engine runs at idle and
functions as start position.
When the engine speed increases, the centrifugal
clutch drive automatically engages the cutting wheel.
O
N
O
F
F
Operator Presence (OP) Grip Bar
The bar must be held against the handle for the engine
to run. If the grip is released, the ignition system short-
circuits and the engine stops.
WARNING!
Do not over-ride the safety system
by binding the bar to the handle.
Control Panel On/Off Engine Switch
The ON/OFF engine switch can be used to stop the
engine. The illustration shows the toggle switch in the
OFF position (short circuited electrical system).
A second switch with the same function is activated by
the OP grip bar.
To start the engine, the control panel switch must be
set to the ON position and the OP grip bar must be
held in.