Filter
Top Products
OPERATION
HUSQVARNA-31
Before moving the machine forwards, you should 11.
ensure that the cutting wheel is above the ground
and located on either side of the stump. Move the
machine forward by releasing the brake, pushing it
forward, activating the brake again and repeating
Steps 9 and 10.
Repeat Steps 9 through 11 until the upper portion 12.
of the stump has been removed. DO NOT cut
deeper than ground level at this stage.
Set the throttle to SLOW/(START) DISENGAGE 13.
and wait until the cutting wheel stops rotating.
Release the brake and pull the machine away from 14.
the stump.
It may be necessary to clear wood chips from the 15.
area around the stump.
If you want to grind below the ground level, it may 16.
become necessary to adjust the handle position to
achieve a better hand and arm work position. Pull
the handle control lever and adjust the handle to
the desired position.
Repeat Steps 6 through 10 until you reach the 17.
desired depth.
Shut off the machine when you are done.18.
Operating On Hills
Be very careful when operating the stump grinder
on hills because the machine can slip or move
unexpectedly.
NEVER use the machine on grades of 10° or steeper.
Transport
The Husqvarna stump grinder can be transported in a
truck, trailer, van or a large SUV (Sport Utility Vehicle).
The stump grinder is equipped with four lifting handles
(two on each side) so that two people can lift the
machine if necessary.
DO NOT attempt to lift the machine alone. Use safe
lifting techniques and DO NOT exceed your physical
limitations.
Secure the machine with tensioning belts, chains or
other approved materials.
O
N
O
F
F
The lifting handles can also be used to secure the machine
for transport.