Filter
Top Products
MAINTENANCE
HUSQVARNA-33
Maintenance Schedule
The following is a list of maintenance procedures
that MUST be performed on the machine. For those
points not described in this manual, visit an authorized
service workshop.
1)
First change after 20 hours.
2)
In dusty conditions maintenance is required at shorter intervals.
3)
Before each use.
4)
Performed by authorized service workshop.
5)
Performed every second year.
6)
Grease every 4 hours.
Daily -/10 1/25 3/50 6/100 12/300
MAINTENANCE
Check engine oil level
n
Change engine oil
1)
n
Check air lter
n
Clean air lter
2)
n
Replace air lter cartridge
2)
n
Clean sludge reservoir for fuel system
n
Check and clean spark plug
n
Replace spark plug
n
Check engine switch function
3)
n
Check idle speed
n
Check and adjust play in valves
4)
n
Clean fuel tank
4)
n
Check, replace fuel lines as necessary
4, 5)
n
Check throttle and cable
3)
n
Check blade and cutter
3)
n
Check decals and warning signs
3)
n
Check wear and tension on belts
3)
n
Check chassis, bolts and set screws
n
Grease the blade bearings (use high temperature grease
such as Mobilith SHC 220 or equal)
6)
n
Grease the wheels (standard lithium base)
n
Check tire air pressure (25 psi max)
n
WARNING!
No service operations may be
performed on the engine or unit
unless:
The engine is stopped.
The ignition cable has been removed
from the spark plug.
The machine is securely parked
where it will not tip or begin rolling.
MAINTENANCE INTERVALS - MONTHS/HRS