Filter
Top Products
MAINTENANCE
40 - HUSQVARNA
IMPORTANT INFORMATION
If pulley on cutter head shaft must be moved,
the set screws MUST be fully removed, fresh
“Loctite 242” put on threads and re-torqued to
100 - 110 in./lbs. (17513 / 19264 N•m).
8011-228
A C B
Loosen the locking nuts (B) on the two tension 5.
bolts.
Turn the two tension bolts (C) counter-clockwise to 6.
loosen the belt or clockwise to tighten it.
CHECK CLUTCH &
PULLEY ALIGN
USING INSIDE FACE
Check that the pulleys are aligned using a straight 7.
edge along the inside face of the clutch and pulley.
Pulleys must be inline. Maximum gap or mis-
alignment is
1
/16" (.062) or 15.7 mm. Adjust using
the tension bolts as necessary. Check belt tension
again.
Tighten all screws and nuts when the adjustment 8.
is complete. Be certain cover plate is not rubbing
against cutter wheel shaft.
Ret the belt guard.9.
8011-229
WARNING!
The cutters can come loose from
the cutting wheel if the bolts are not
sufciently tight. Comply with the
recommended torque settings.
Cutting Wheel
TOOTH CUTTER
(CARBIDE FACE)
Tighten the screws 30 ft/lbs. (133 Nm).