Filter
Top Products
OPERATION
30 - HUSQVARNA
IMPORTANT INFORMATION
If the cutting wheel is too low, the machine
may start to “climb” over the stump and
become unstable.
Tilt the machine on its wheels, lifting the cutting 5.
wheel off the ground.
Hold in the OP grip bar and start the engine.6.
Allow the engine to warm up for two minutes at 7.
idle before grinding.
8060-027
Set the handle throttle to FAST to engage clutch.8.
Place the middle of the cutting wheel 9.
approximately 1" (2.5 cm) above and ¾" to 1½"
(2-4 cm) into the stump.
Place the cutting wheel in the upper front edge of 10.
the stump. Swing the cutting wheel from side to
side while lowering it about 1" (2.5 cm) after each
pass until the front edge of the stump is gone.
8011-203a
8060-200