Filter
Top Products
Media tray
This section describes removing and opening the media tray.
Removing the media tray
Complete the following steps to remove the media tray.
Note:
v Read “Installation guidelines” on page 31.
v Read the safety notices at “Safety information” on page 87.
v Read “Handling electrostatic discharge-sensitive devices” on page 90.
1. Remove the BladeCenter bezel.
a. Press the release pads at the bottom corners of the bezel.
b. Swing the bezel up and off the BladeCenter.
2. Push the tabs on the left and right sides of the tray to the left and right
respectively; then, pull the media tray out of the BladeCenter.
Reverse these instructions to reinstall the media tray.
Removing the media-tray cover
Complete the following steps to remove the media tray cover.
Note:
v Read “Installation guidelines” on page 31.
v Read the safety notices at “Safety information” on page 87.
v Read “Handling electrostatic discharge-sensitive devices” on page 90.
1. Lift at the points indicated in the illustration to lift the rear of the tray cover off
the fasteners.
2. Slide the cover toward the rear of the tray until the front tabs are clear of the
slots in the tray; then, lift the cover off the tray.
Note: The diskette drive shown in the following illustration is not present in all
BladeCenter unit models.
48 BladeCenter E Type 8677 and 1881: Hardware Maintenance Manual and Troubleshooting Guide