Filter
Top Products
Shipping
bracket
Release
latch
SPC chassis
thumbscrews
SPC chassis
thumbscrews
a. To disengage the shipping brackets, slide the shipping brackets towards the
blowers.
7. Unscrew the captive thumbscrews at the bottom corners of the chassis, and pull
them until the SPC chassis moves out about 1.27 cm (0.5 inches).
8. Pull the SPC chassis out until it stops (about half-way out).
9. While supporting the SPC chassis with your hands, press the release levers on
the sides, and pull the SPC chassis out of the BladeCenter unit. Place the SPC
chassis on a strong, flat surface.
To reinstall the SPC chassis, reverse the previous steps.
Media-cable tray
Note: The media cable is only present in BladeCenter unit models that have a
media tray with a diskette drive.
The media-cable tray is between the media tray and the SPC chassis.
Complete the following steps to remove the media cable tray.
Note:
v Read “Installation guidelines” on page 31.
v Read the safety notices at “Safety information” on page 87.
v Read “Handling electrostatic discharge-sensitive devices” on page 90.
1. Remove the BladeCenter bezel.
a. Press the release pads at the bottom corners of the bezel.
b. Swing the bezel up and off the BladeCenter.
2. Push the tabs on the left and right sides of the tray to the left and right
respectively; then, pull the media tray out of the BladeCenter.
Chapter 5. Service replaceable units 53