Filter
Top Products
2-12 Installation
Problem Prevention
The following are things that you MUST NEVER do:
1) Never connect or disconnect the printer cable while either the computer or the
laser system is powered ON. Always power down both units and leave them plugged into
the wall outlet when connecting or disconnecting the printer cable.
2) Never connect the laser system through a manual switch type A/B switch box. If
connecting an additional laser system or other printer to the same computer, we recommend the
installation of an additional parallel port into the computer. Using a switchbox can create
electrical noise that can cause an engraving problem or can damage the laser system and/or the
computer’s electronics.
3) Never use any device that is installed between the computers parallel port and
the parallel port of the laser system such as a ZIP drive or parallel port CD-ROM
drive. This can not only damage the laser systems electronics but it usually will not work and
will cause file transmission errors. Again, install an additional parallel port for other peripheral
devices.
Computer Controlling the Laser System
At this time, you will need to read the second manual supplied with your system. It is called
“Computerized Controls”. This manual contains Windows 95/98 printer driver installation and
operation instructions as well as setup instructions for graphics software to properly work with
the laser system. Please read this other manual before continuing on to Section 3.
Ihr ULS Vertragshändler :
MarkIDent GmbH
Winterspürerstr. 19
78333 Stockach
www.markident.de